Turn Roll Assembly Removal (Pl3.1.11) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.6.2 TURN ROLL ASSEMBLY Removal (PL3.1.11)

1. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
2. Remove the UNIVERSAL TRAY. (See Section 3.2.5.1.)
3. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
4. Remove the MAIN P/H ASSEMBLY with the MSI TRAY ASSEMBLY
installed on it. (See Section 3.2.8.1.)
5. Remove the TURN IN CHUTE. (See Section 3.2.6.1.)
6. Remove 2 screws (silver, 6mm) securing the TURN CHUTE and
remove the TURN CHUTE.
7. Remove 1 screw (silver, 8mm) securing the FEED GUIDE SHAFT
and remove the FEED GUIDE SHAFT.
8. Remove 2 screws (gold, cup head, 8mm) securing the TRAY
STOPPER and remove the TRAY STOPPER.
9. Remove TURN ARM SPRING from the TURN ARM ASSEMBLY
and the frame.
10. Remove the E-ring securing the TURN ROLL ASSEMBLY.
11. Shift the TURN FRONT BEARING to the rear and remove the
bearing.
12. Shift the TURN ROLL ASSEMBLY forward to release the rear end
and shift the rear part of the assembly to the right. Then, shifting the
assembly to the rear, remove it along with the TURN FRONT
BEARING, TURN REAR BEARING, and TURN ARM ASSEMBLY.
13. Remove the TURN FRONT BEARING AND TURN REAR
BEARING from the TURN ROLL ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
NOTE: In the next step, the pulley and the gear in the TURN ROLL
ASSEMBLY will dislocate. Therefore, be careful not to drop
and lose them.
14. Remove the E-ring securing the TURN ARM ASSEMBLY and the
TURN ARM SUPPORT, and remove the TURN ARM ASSEMBLY.
15. Remove the TURN GEAR, TURN GEAR PIN, and the TURN ARM
STOPPER from the TURN ROLL ASSEMBLY.
Figure 3-19. TURN ROLL ASSEMBLY Removal
When installing the TRAY STOPPER, verify that the
stopper is at the right position by moving the MSI tray in
and out to see if the tray is securely supported.
Revision A
3-19