Epson ColorPage EPL-C8200 Service Manual page 469

EPSON ColorPage EPL-C8200

Location


To operate properly, a certain amount of space around the
printer is required. (For details, see Chapter 1/Section 1.2.4.)


The printer is located in an area where the temperature and
humidity are moderate and stable.


The printer is located in an area away from water outlets,
steamers, heaters, air conditioners or open flame.


The printer is located in an area that is free of dust, volatile
gases or flammable gases.


The printer is shielded from the direct ray of the sun.


The printer has recommended space around all sides for proper
ventilation.


The printer is sitting on a level and stable surface.

Unpacking
When unpacking the printer from the carton, make sure the packed
items listed below and that they are not damaged.
1) Printer (Including the UNIVERSALLY TRAY)
2) DRUM CARTRIDGE
3) TONER CARTRIDGE Y
4) TONER CARTRIDGE M
5) TONER CARTRIDGE C
6) TONER CARTRIDGE BK
7) OIL ROLL ASSEMBLY
8) MSI TRAY ASSEMBLY
9) EXIT TRAY ASSEMBLY
10) Power Cord
11) Accessory box
Chapter 6 Maintenance

Installation Procedure
The following describes the installation procedures. For details, see
the User's Guide.


The printer weighs about 69 kg. To prevent injury,
the printer should be carried by four persons.


Lift the printer with both hands putting into the
dented holds. If you hold on to any other parts, you
may drop or damage the printer.


Lift the printer with your knees bent to prevent
back injuries.
NOTE:Keep the protection sheet, spacers and packing materials in
case of moving the printer in future.
1) Open the carton and remove the packing materials. Place the
printer where it is to be installed.
2) Remove the protective tapes securing the printer.
3) Check the items that are packed with the printer.
4) Install the MSI TRAY ASSEMBLY on the MSI ASSEMBLY.
5) Install the EXIT TRAY ASSEMBLY on the FUSER ASSEMBLY.
6) Open the FRONT COVER ASSEMBLY.
NOTE:Do not touch the drum surface of the Drum Cartridge.
7) Install the DRUM CARTRIDGE in the printer.
8) Remove the spacer from the area where the toner cartridges are
installed. (The spacer prevents the toner cartridges from rotating.)
Revision A
6-18