Regi. Clutch Removal (Pl5.2.15) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.8.7 REGI. CLUTCH Removal (PL5.2.15)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
NOTE: In the following step, hold the REGI. CHUTE ASSEMBLY to
keep it closed while turning over the MAIN P/H ASSEMBLY.
4. Disconnect the connector (P/J94) for the REGI. CLUTCH from the
back of the MAIN P/H ASSEMBLY and release the harness.
NOTE: In the following step, be careful not to lose the REGI.
UPPER BEARING, since it may come off when the REGI.
CLUTCH is removed.
NOTE: In the following step, be careful not to lose the REGI.
SPACER.
5. Pull the connector (P/J94) through the harness hole to the rear side
of the MAIN P/H ASSEMBLY.
6. Remove the E-ring fixing the REGI. CLUTCH, and remove the
REGI. SPACER and REGI. CLUTCH from the stud to the rear.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-50. REGI. CLUTCH Removal
When installing the REGI. CLUTCH, align the notch on
the REGI. CLUTCH with the pin on the P/H FRAME
ASSEMBLY.
Revision A
3-44