EPSON ColorPage EPL-C8200
1.2 Specifications
This section describes specifications for this printer.
1.2.1 Basic Specifications
Method:
Semi-conductive laser beam scanning and
dry electrophotographic process
Resolution:
600 DPI
Print mode:
B/W mode:
Standard monochrome print mode that
supports the fastest speed.
Color mode:
Color mode which uses the color toner of Y,
M, C, and BK.
Speed mode:
Standard mode:
Transports paper at the highest speed
supported by the printer.
Half speed mode: Low speed mode that enables better fusing
for thick paper (over 105g/m
OHP sheet.
Print speed:
See Table 1-1.
Chapter 1
Product Descriptions
Print mode
B/W
Color
*1: [LEF, or Long Edge Feed]
The longer edge of the paper is the top toward the paper feed direction.
[SEF, or Short Edge Feed]
The shorter edge of the paper is the top toward the paper feed direction.
*2: In this mode, the printer prints two print images on the IBT belt and the images
are transferred in sequence onto two sheets of paper. It is available for LT/A4
(LEF) or smaller.
First print*:
NOTE: First print is defined as the duration taken after receiving the
2
) envelopes, and
Warm-up time:
Table 1-1. Speed Mode
Speed mode
LT/A4 LEF
Standard mode
16 PPM or more
Half speed mode 2.7 PPM or more
Standard mode
4 PPM or more
half speed mode
1.8 PPM or more
Face-up:
B/W:
20 seconds or less (LT/A4 LEF)
Color:
42.6 seconds or less (LT/A4 LEF)
Face-down:
B/W:
24.9 seconds or less (LT/A4 LEF)
Color:
47.6 seconds or less (LT/A4 LEF)
start command until outputting the first print. It is applicable
when a feeder is selected in the standard mode. (Not
applied during the process control operation.)
Within 300 seconds
(at 22 C, 55% Rh, rated voltage)
Revision A
*1
*2
*1
2UP
B(LD)/A3 SEF
8PPM or more
1.3PPM or more
2PPM or more
0.9PPM or more
1-3