Displaying The Log - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

4.2.4.6 Displaying the log

The communication log shows you how the commands and status are
exchanged between the Diagnostic Commander and the MCU PWB.
Run [Log Window] to see the log.
Displaying the Log Window
1. Move the cursor to the white area (blank area) in the main window
of the [Renoir Service Commander]. Click the right mouse button.
The [Log Window Open] button appears.
2. Click the [Log Window Open] button. The [Log Window] appears.
3. The commands and status that have been sent/received are
displayed in HEX in the [Log Window].
4. In the [Log Window], a voluntary status from the printer which does
not require a command is also displayed. (A voluntary status is not
shown in the [Status] box.)
NOTE: The following shows the voluntary status that are not displayed
in the [Status] box.
- IGNORED40 XX (CMD) XX (REASON)
- PPOUT20 XX (DEST) XX (DOPT) XX (SHEET)
- PCH21 XX (CASSETTE) XX (SIZE) XX (MEDIA)
- PFA30 XX (AMODE) XX (SHEET1) XX (SHEET2)
- ENGERR31
- ERRRV32
- ENGWRN33
Chapter 4 Diagnostics
>>: Command, <<: Status
Operating the Log Window
Move the cursor inside the Log Window. Click the right mouse button.
The [Log Clear], [Log Save] and [Log Window Close] buttons appear.
Click the appropriate button.
 [Log Clear]
Clears the log and erases the display in the Log Window.
 [Log Save]
Saves the log. If you click this button, the [Log Save] window
appears. Specify a file name and click the [Save] button. If you
do not specify the file extension, the system automatically adds
the file extension (.LOG).
 [Log Window Close]
Closes the Log Window.
NOTE: You can open the saved log file by using an editor (e.g.,
WordPad).
Revision A
The communication has been established
Status
Command
4-16