Developer Removal (Pl7.1.13, Pl7.1.23, Pl7.1.33, Pl7.1.43) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.10.3 Developer Removal (PL7.1.13, PL7.1.23, PL7.1.33, PL7.1.43)

NOTE: The generic term "Developer" is used for "DEVELOPER Y/M/C/
K".
NOTE: The generic term "Deve. Upper Assembly" is used for "DEVE.
UPPER ASSEMBLY Y/M/C/K".
1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
3. Remove the TENSION LEVER. (See Section 3.2.11.1.)
4. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
5. Remove the Toner Cartridge from the Developer Assembly in the
replacing position. (See Section 3.2.10.1.)
6. Remove the TOP COVER SWITCH. (See Section 3.2.16.3.)
7. Remove the Developer Assembly that has the Developer to be
removed. (See Section 3.2.10.2.)
NOTE: Before proceeding to the next step, note the points below.


Do not scatter toner.


Place the Developer Assembly on a sheet of paper set on a
desk or floor.


Get a sheet of paper on which you place the Developer.


Be careful not to drop and lose the gear as it may dislocate
when the bracket of the developer is removed.
8. Remove 2 screws (gold, tapped, 8mm) and 1 screw (gold, 6mm)
securing the bracket.
9. Remove 4 screws (gold, tapped, 8mm) securing the Deve. Upper
Assembly. Then release 4 hooks on the Deve. Upper Assembly and
shift the Deve. Upper Assembly forward to remove.
10. Place the Developer on a sheet of paper.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-68. Developer Removal
Do not use the Developer that is once taken out.
Revision A
3-59