Epson ColorPage EPL-C8200 Service Manual page 337

EPSON ColorPage EPL-C8200
Paper Set sss ttt
LED: On Line = off, Continue = blinking
Description: The paper loaded in the selected paper source sss
does not match the specified paper size ttt.
Remedy: When "Size Ignore" in the "Config" menu = Off and
"Auto Cont" in the "Config" menu = Off, take any of
the following actions:
1. Set the paper of size ttt in the paper source sss
and press the Continue button. The error is
cleared and the printer feeds paper from the
paper source sss to resume printing.
2. Press the Continue button without changing the
paper. The error is cleared and the printer
resumes printing on paper from the paper source
sss.
3. Reset the printer or perform a warm boot.
When "Size Ignore" in the "Config" menu = Off and
"Auto Cont" in the "Config" menu = On, the printer will
automatically override the paper mismatch error after
a specified period of time and resume printing on
paper from the paper source sss.
Print Overrun
LED: On Line = off, Continue = blinking
Description: The print data is so complicated that the printer
cannot process the data quickly enough.
Remedy: When "Auto Cont" in "Config" menu = Off, perform
any of the following:
1. If the printer has enough memory, it will attempt
to print one more time, which may bring up the
same error. If there is not enough memory or if
Chapter 5 Troubleshooting
the Print Overrun error recurs, however, the data
for that page will be lost and the printer will begin
processing the next page of data.
2. Reset the printer or perform a warm boot.
When "Auto Cont" in "Config" menu = On, the printer
will automatically override the error after a specified
period of time and undergo the same process as
described above.
Mem Overflow
LED: On Line = off, Continue = blinking
Description: While processing a print job, the printer ran out of
memory.
Remedy: When "Auto Cont" in "Config" menu = Off, perform
either of the following:
1. Press the Continue button. The action follows
varies depending on the cause of the error. If the
size of the graphic data has exceeded the buffer
size, the printer ejects the page before the error,
ignoring the command that caused the error. If
the cause of the error is a failure in registering the
font macro pattern or so, the printer ignores the
bad command and continues to print.
2. Reset the printer or perform a warm boot.
When "Auto Cont" in "Config" menu = On, the printer
will automatically override the error after a specified
period of time and undergo the same process as
described above.
Revision A
5-9