Temp. Sensor Assembly Removal (Pl9.2.24) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.12.12 TEMP. SENSOR ASSEMBLY Removal (PL9.2.24)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
5. Remove the FUSER UPPER ASSEMBLY. (See Section 3.2.12.4.)
6. Remove the H/R HEATER. (See Section 3.2.12.5.)
7. Remove the P/R HEATER. (See Section 3.2.12.6.)
8. Remove the LOWER GUIDE ASSEMBLY. (See Section 3.2.12.7.)
9. Remove the UPPER GUIDE ASSEMBLY. (See Section 3.2.12.9.)
10. Remove the HEAT ROLL. (See Section 3.2.12.10.)
11. Remove the PRESSURE ROLL. (See Section 3.2.12.11.)
12. Remove the screw (black, cup head, 16mm) securing the FUSER
REAR FRAME and remove the FUSER REAR FRAME and the
FUSER REAR BRACKET along with 2 gears.
13. Remove the screw (black, cup head, 16mm) securing the FUSER
FRONT FRAME and remove the FUSER FRONT FRAME and the
FUSER FRONT BRACKET along with the NIP SCREWs.
14. Disconnect the connector (P/J75) from the FUSER EXIT SENSOR
and release the harness from the hook on the FUSER BOTTOM
PLATE. Then remove the TEMP. SENSOR ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-104. SENSOR ASSEMBLY Removal


After installing the TEMP. SENSOR ASSEMBLY,
perform the adjustment "NIP adjustment of the MAIN
FUSER ASSEMBLY". (Refer to Section 3.3.1.)


Route the harness tightly via the hook on the FUSER
BOTTOM PLATE.
Revision A
3-86