Table of Contents
Advertisement
5. Press the
6. Check the LCD screen and do the following:
• If you see a message that says the media surface is too high, go to the next step.
• If the Home screen is displayed, press the
loosen the platen gap fixing lever and then move the lever to the left by one notch on the scale.
Tighten the fixing lever, secure the platen gap lever, and then press the
to move the platen back. Repeat the process until a message that says the media surface is too
high appears on the screen.
Note: If the A and B spacers are installed and aligned with the P scale, you cannot raise the
platen height any further.
7. Press the
8. Loosen the platen gap lever fixing lever and then move the lever to the right by two notches on the
scale.
Note: The "." dot marks on the scale between the numbers are also counted as one notch. If the
message is displayed while the scale is at 3, move it to 4.
9. Tighten the fixing lever to secure the platen gap lever.
Parent topic:
Related tasks
Changing the Platen Height
Attaching or Removing Spacers
Checking Spacer Combinations and Platen Height (Scale)
Message Is Displayed After Cleaning the Encoder Strip (Carriage Scale)
If a cleaning message is displayed on the LCD screen after you have cleaned the encoder strip (carriage
scale), make sure that no dust or ink cleaner remains on the encoder strip (carriage scale). If the
cleaning message appears again, contact Epson for support.
Parent topic:
Related references
Where to Get Help (U.S. and Canada)
Where to Get Help (Latin America)
moveable base button to move the platen inside the printer.
moveable base button to move the platen forward.
Solving Printing Problems
Solving Printing Problems
moveable base button to move the platen forward,
169
moveable base button
Advertisement
Table of Contents
