Epson ColorPage EPL-C8200 Service Manual page 336

EPSON ColorPage EPL-C8200
Manual Feed sss ttt
LED: On Line = off, Continue = Blinks
Description: When "Manual Feed" is enabled by the command or
panel operation, this error occurs when print is
requested.
Remedy: 1) Set paper in the indicated paper source and
press the Continue or On Line button, and the
printer prints on and indicates the same error
when loading paper for the next page. When
copy was selected, result varies depending on
the button pressed, Continue or On Line, as
shown below:
<  >
The error does not occur during copying, except
for the case paper has run out.
<    >
The error message appears after each page
including copied page. A "Check Paper Size"
error does not occur if "Size Ignore" in Config
menu is disabled.
2) Press the Continue button or On Line button
without setting any paper in the indicated paper
source. Paper is loaded from the available paper
source with the highest priority. If neither of the
paper sources has paper in it, the same error
occurs. (This circumstance does not generate a
"Paper Out" error.) Other actions affect the same
as for the remedy 1).
3) Perform Reset or Warm boot.
Chapter 5 Troubleshooting
Insert sss
LED: On Line = off, Continue = off
Description: Paper feed cassette indicated by sss is out.
Remedy: Instal the missing cassette. The error is automatically
cleared.
Paper Out sss ttt
LED: On Line = off, Continue = off
Description: 1) There is no paper loaded in the selected paper
source sss.
2) Paper is set in none of the paper sources. (In this
case, the paper source previously used is
indicated. If this condition is detected at power
on, however, "LC1" is indicated.)
"ttt" shows the paper size selected for the paper
source sss.
Remedy: 1) Load the correct size of paper ttt in the paper
source sss to clear the error.
2) Load the correct size of paper in any of the paper
sources to clear the error.
Revision A
5-8