Fip-1.48 Sram (Ic25) Initialization Error; Fip-1.49 Built-In Network Hardware Error - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200
FIP-1.48 SRAM (IC25) Initialization Error
Step Check point
Perform the preliminary inspection below:
• Remove all electrical unit modules to return the printer
to the standard condition.
1
• Check that all connectors are properly connected to the
CONTROLLER PWB.
Check: CONTROLLER PWB or IC25 replacement
2
Replace the CONTROLLER PWB or IC25.

Does the problem still occur?
FIP-1.49 Built-in Network Hardware Error
Step Check point
Perform the preliminary inspection below:
• Remove all electrical unit modules to return the printer
to the standard condition.
1
• Check that all connectors are properly connected to the
CONTROLLER PWB.
Check: Network setting
• Check that the current network is operating properly.
• Run a network status sheet and check that each setting
2
is correct.
• Check that each setting on the client side is correct.

Does the problem still occur?
Chapter 5 Troubleshooting
Yes
Replace/reinstall the defective part(s).
-
Yes
Replace/reinstall the defective part(s).
Replace the CONTROLLER PWB.
Remedy
No
Go to Step 2.
Problem solved.
Remedy
No
Go to Step 2.
Problem solved.
Revision A
5-61