Adc Sensor Assembly Removal (Pl6.1.20) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.9.4 ADC SENSOR ASSEMBLY Removal (PL6.1.20)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
3. Remove the TENSION LEVER. (See Section 3.2.11.1.)
4. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
5. Disconnect the connector (P/J81) for the ADC SENSOR
ASSEMBLY. Then release the harness from the clamp and pull it
out from the harness hole to bring it to the inner side.
NOTE: In the following step, keep your hands off the IBT BELT
ASSEMBLY and the Magnet roll in the DEVELOPER
ASSEMBLY.
6. Remove the E-ring securing the ADC SENSOR ASSEMBLY.
7. Shift the ADC SENSOR ASSEMBLY to the rear to release the front
end from the frame. Then release the rear end of the shaft from the
frame, and take the ADC SENSOR ASSEMBLY out to the front.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-61. ADC SENSOR ASSEMBLY Removal
When installing the ADC SENSOR ASSEMBLY, be sure
to set the shaft of the assembly securely to the front
and rear frames of the printer body.
Revision A
3-53