Retard Pad Assembly Removal (Pl4.3.3) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.7.9 RETARD PAD ASSEMBLY Removal (PL4.3.3)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MSI FRONT COVER. (See Section 3.2.7.3.)
4. Remove the MSI REAR COVER. (See Section 3.2.7.4.)
5. Remove the MSI TOP COVER ASSEMBLY. (See Section 3.2.7.5.)
6. Remove the PICK UP ROLL. (See Section 3.2.7.8.)
7. Hold the MSI BOTTOM ASSEMBLY down.
NOTE: In the following step, if the FRONT CORE ROLL is above the
RETARD PAD ASSEMBLY, shift it further away until it is not
above the RETARD PAD ASSEMBLY.
NOTE: In the following steps, note the following:
- Be careful not to break the hook and hinge.
- Be careful not to drop and lose the RETARD SPRING as
it may dislocate.
8. Using the standard driver or equivalent, push the hook on the
RETARD PAD ASSEMBLY to release the hook from the MSI
FRAME, and turn the RETARD PAD ASSEMBLY to the right.
9. Set the pad surface of the RETARD PAD ASSEMBLY vertical, then
remove the RETARD PAD ASSEMBLY along with the RETARD
SPRING pulling them out to the right.
10. Remove 2 RETARD SPRINGs from the RETARD PAD ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
After installing the RETARD PAD ASSEMBLY,
align the RETARD SPRING with the groove on
the MSI FRAME by using tweezers.
Figure 3-35. RETARD PAD ASSEMBLY Removal
Revision A
3-32