Fip-1.9 Paper Jam - Fuser - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

FIP-1.9 Paper Jam - FUSER

Step Check point
Perform the preliminary inspection.
Parts to inspect:
1
FUSER EXIT ACTUATOR, FUSER EXIT SENSOR,
FUSER IN ACTUATOR, FUSER IN SENSOR, FUSER
DRIVE ASSY, MCU PWB
Isolation: Engine or Controller?
Run the Engine test print or diagnostic test print.
2
(10 sheets for each of single and continuous print)

Are the outputs normal?
3
Is the current paper curled or easy to curl?
Check: FUSER EXIT ACTUATOR

Is the FUSER EXIT ACTUATOR properly functioning
depending on the conditions below?
- Paper is set:
The actuator is away from the detection area of the
4
FUSER EXIT SENSOR.
- No paper is set:
The MSI N/P ACTUATOR is blocking the detection
area of the FUSER EXIT SENSOR?

Does the actuator move smoothly?
Check: FUSER EXIT SENSOR

Is the FUSER EXIT SENSOR properly functioning?
5 (Check it by using the diagnostic tool.)
Diag Tool: Digital Input Test
Device Code: 25
(To be continued.)
Chapter 5 Troubleshooting
Yes
Replace/reinstall the defective part(s).
Check the Controller PWB.
If the problem still occurs, go to step 3.
Change the paper.
• With the diagnostic tool, go to step 5.
• Without the diagnostic tool, go to FIP-
2.28 "FUSER EXIT SENSOR is
Defective".
If the problem still occurs, go to FIP-2.27
"FUSER IN SENSOR is Defective".
Go to Step 6.
Remedy
No
Go to Step 2.
Go to Step 3.
Go to Step 4.
Replace the defective part.
Go to FIP-2.28 "FUSER EXIT SENSOR
is Defective".
Revision A
5-26