Epson ColorPage EPL-C8200 Service Manual page 160

EPSON ColorPage EPL-C8200
8. Remove 2 screws (black, cup head, 8mm) securing the LOCK PLATE
by the right edge.
9. Remove 2 screws (black, cup head, 8mm) securing the LOCK PLATE
by the left edge, and remove the LOCK PLATE.
10. Remove 2 screws (gold, tapped, 8mm) securing the REAR GUIDE
PLATE L.
NOTE: In the following step, hold the REAR GUIDE while removing
the REAR GUIDE PLATE R. so that the REAR GUIDE will
not drop.
11. Remove 1 screw (gold, tapped, 8mm) securing the REAR GUIDE
PLATE R and remove the REAR GUIDE R and the REAR GUIDE.
NOTE: In the following step, TRAY N/F SPRINGS will spring out.
Therefore, be careful not to lose them.
12. Moving the PLATE LINK, unlock the BOTTOM PLATE ASSEMBLY
and open it. Then slide the END GUIDE further right and remove it.
When installing the SECTOR GEAR, make sure that the
triangle marks on the SECTOR GEAR and TRAY SIZE
ACTUATOR are aligned.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-17. END GUIDE (PL2.2.16), SECTOR GEAR (PL2.2.17)
Removal (2)
Revision A
3-17