Warning Message - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

5.1.3 Warning Message

Warning errors have no effect on printer operation.
Table 5-15. Warning Message List (1/4)
o Format Error ROM g
LED Message No effect on LED state.
Explanation It is possible to format the ROM module, but the installed
ROM module in slot A or B is wrong format.
If the module has not previously been formatted, there is no
problem. If the module has been previously
formatted, it was not formatted properly or the memory was
damaged. Either reformat the module or turn
off the printer and remove the module.
Solution Perform one of the following to clear the warning.
Press the Continue button.
1.
Turn off the printer and remove the ROM module.
2.
Perform a Reset operation.
3.
o Need Memory
LED Message No effect on LED state.
Explanation While processing print data, the printer ran out of memory and
attempted to compress the data. However the printer
reached its compression limit and generated this warning. In
some cases the printer can process the data and print
even after this warning message appears. If the user presses
the Continue button and the printer reaches the
compression limit again while attempting to process the data,
the printer will reduce the resolution of the print data
and will generate an "Image Optimum" warning. (This
message has higher priority. Note: It is not possible to change
the compression limit for this printer.
Solution This messages remains even after the print job has finished
printing. Perform one of the following to clear the warning.
Press the Continue button to clear the error and try to
1.
print the remainder of the print job.
Perform a Reset operation or warm boot.
2.
Note: Installation of additional memory (optional SIMM) is
recommended.
Chapter 5 TROUBLESHOOTING
Table 5-16. Warning Message List (2/4)
o Image Optimum
LED Message No effect on LED state.
Explanation There was not enough memory to process the print data and
the printer optimized the data (reduced the resolution).
Solution This message remains even after the print job has finished
printing. Perform one of the following to clear the warning.
Press the Continue button to clear the warning.
1.
Perform a Reset operation or warm boot to exit while
2.
the printer is processing data.
o Check Paper Size
LED Message No effect on LED state.
Explanation This warning only appears when the Size Ignore setting on
the Device menu is disabled.
The selected paper size (PAGE SIZE) and the size of the
paper loaded in the selected paper source do not match.
When the paper was fed from the paper tray, if this error does
not occur, the value for MP tray size in the printing menu is
replaced with the value for the PAGE SIZE.
Depending on the paper size, the printer may not be able to
detect some paper size mismatches.
Note: When this warning occurs, be sure to check to
see if any pages (of the wrong size) were printed before
the printer detected the paper size mismatch
Solution Perform one of the following to clear the warning.
1. Press the Continue button to clear the error.
2. Perform a Reset operation or warm boot.
o u u u u Toner Low
LED Message No effect on LED state.
Explanation The engine has detected (by measuring the dispense time)
the toner level for one or more Toner Cartridges has fallen
below 80%. The uuuu area indicates which Toner Cartridge is
low, Y, M, C, or K.
Solution See the next table.
Rev. B
.
5-9