Fip-1.25 Cassette 1 Is Out - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

FIP-1.25 CASSETTE 1 is Out

Step Check point
Perform the preliminary inspection.
Parts to inspect:
1
UNIVERSAL CASSETTE, TRAY SIZE ACTUATOR,
SIZE SWITCH ASSY, FEEDER PWB, MCU PWB
Isolation: Engine or Controller?
Run the Engine test print or diagnostic test print.
2
(10 sheets for each single and continuous print)

Are the outputs normal?
Check: UNIVERSAL CASSETTE
3
Can you insert the UNIVERSAL CASSETTE smoothly?
Check: TRAY SIZE ACTUATOR
1. Insert a sheet of paper from the rear side onto the
SIZE SWITCH ASSY.
2. Install the cassette 1.
4
3. Pull out the sheet. If you feel resistance, it means
the Paper Size Switches are pushed.

Does the TRAY SIZE ACTUATOR push the Paper Size
Switches when the cassette 1is installed?
Check: Paper size

Is the SIZE SWITCH ASSY functioning properly?
5
Check the paper size using the diagnostic tool.
Diag Tool: Analog Input Test
Device Code: 02
Check: FEEDER PWB replacement
6
Replace the FEEDER PWB with a good one.

Does the problem still occur?
Chapter 5 Troubleshooting
Yes
Replace/reinstall the defective part(s).
Check the Controller PWB.
If the problem still occurs, go to step 3.
Go to Step 4.
• With the diagnostic tool, go to step 5.
• Without the diagnostic tool, go to
FIP-2.5 "SIZE SWITCH ASSY is
Defective".
• If an optional Large Capacity Paper
Unit or 500-Sheet Paper Cassette
Unit, go to Step 6.
• Replace the MCU PWB.
Replace the MCU PWB.
Remedy
No
Go to Step 2.
Go to Step 3.
Replace the defective part.
Go to FIP-2.5 "SIZE SWITCH ASSY is
Defective".
Problem solved.
Revision A
5-42