Developer Assembly Removal (Pl7.1.10, Pl7.1.20, Pl7.1.30, Pl7.1.40) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.10.2 Developer Assembly Removal (PL7.1.10, PL7.1.20, PL7.1.30, PL7.1.40)

NOTE: The generic term "Developer Assembly" is used for
"DEVELOPPER ASSEMBLY Y/M/C/K".
1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
3. Remove the TENSION LEVER. (See Section 3.2.11.1.)
4. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
5. Remove the Toner Cartridge from the Developer Assembly in the
replacing position. (See Section 3.2.10.1.)
6. Remove the FRONT COVER SWITCH L. (See Section 3.2.16.8.)
7. Remove the screw (silver, 8mm) securing the ROTARY LATCH
ASSEMBLY. Then shift the ROTARY LATCH ASSEMBLY right to
release the hook and remove the ROTARY LATCH ASSEMBLY.
NOTE: In the following step, be sure not to drop the screw.
8. Turn the ROTARY FRAME ASSEMBLY until the screw (silver, M4,
22mm) securing the Developer Assembly is aligned with the round
cutout in the frame in front. Then, remove the screw inserting a
driver.
NOTE: In the following step, note the points below.


Never touch the Magnet Roll in the Developer Assembly.


The ROTARY FRAME ASSEMBLY will rotate in the next step
since the ROTARY LATCH ASSEMBLY has been removed.


After removing the Developer Assembly, place it level on a safe
surface.
9. Shift the Developer Assembly forward first. Then lift up the front part
of the Developer Assembly and remove it.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-67. Developer Assembly Removal
Revision A
3-58