Ibt Belt Assembly Removal (Pl8.2.2) - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.11.8 IBT BELT ASSEMBLY Removal (PL8.2.2)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
6. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
7. Pull out the MAIN P/H ASSEMBLY with the MSI ASSEMBLY on it.
(See Section 3.2.8.1.)
8. Remove the ROS ASSEMBLY. (See Section 3.2.9.3.)
9. Remove the ADC SENSOR ASSEMBLY. (See Section 3.2.9.4.)
10. Remove the XL RAIL ASSEMBLY. (See Section 3.2.9.5.)
11. Remove the HVPS. (See Section 3.2.16.2.)
NOTE: In the following step, never touch the IBT BELT surface but
the ribs on the sides.
12. Remove the TRANSFER ASSEMBLY. (See Section 3.2.11.2.)
13. Install the TENSION LEVER and lift up the PUSH IN SHAFT.
14. Wide the arms on the TRANSFER ASSEMBLY to remove the
PUSH IN SHAFT.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-89. IBT BELT ASSEMBLY Removal (1/3)
15. Turn the TENSION LEVER and push down the arms for the PUSH
IN SHAFT, then remove the TENSION LEVER.
16. Push the metallic cam on the
both sides of the TRANSFER
ASSEMBLY inward and
insert a hex driver (allen
wrench) through the hole on
the side to lock the cam.
17. In a side of a table, put up the
IBT DRIVE ROLL
ASSEMBLY of the
TRANSFER ASSEMBLY with
its gear part sticking out.
Figure 3-90. IBT BELT ASSEMBLY Removal (2/3)
Revision A
3-74