Error Message - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

5.1.2.2 Error Message

Error messages are indicated according to priority. Therefore, if multiple
errors have been detected, the message with the highest priority
appears in the LCD.
See the following pages for the error messages and their descriptions
and solutions.
Check OHP Sheet
LED: On Line = off, Continue = off
Description: An OHP sheet was fed upside down. An irregular
OHP sheet was fed into the printer, which caused a
paper jam in the MSI entry slot.
Remedy: If a correct OHP sheet is set, try turning the sheet
over. If an irregular OHP sheet is used, replace it with
a proper OHP sheet. Then open the feed unit,
remove the jammed OHP sheet, and close the unit.
(You must open the feed unit to clear the error.) The
printer starts warming up and resumes printing the
page affected by the error.
Jam xxxxxxxxxxxxxxx
LED: On Line = off, Continue = off
Description: Paper(s) is jamming at indicated position(s)
xxxxxxxxxxxxxxx (
 ,
 , or  ). If multiple
positions are indicated, it means paper(s) is jamming
near the indicated positions, so the numbers of the
indicated positions and jammed papers do not
necessarily match.
NOTE: If EJL is used, only one location is indicated in the following
priority; 1) Exit 2) Fuser 3) Feed.
Chapter 5 Troubleshooting
<
 >
Remedy:
Remove the jammed paper near the paper source
and open the paper feeding unit (and the feeder
cover if Large Capacity Paper Unit or 500-Sheet
Paper Cassette Unit is installed) to check that there
is no paper, then close the unit. You must open the
paper feeding unit (or the feeder if Large Capacity
Paper Unit or 500-Sheet Paper Cassette Unitis
installed) to clear the error. After warming-up, the
printer resumes printing the page that was affected
by the error.
<
 >
Open the Fuser Unit, remove the jammed paper, and
close the unit. The error will be automatically cleared.
After warming up, the printer resumes printing the
page that was affected by the error.
<  >
Open the paper exit cover, remove the jammed
paper, and close the cover. The error will be
automatically cleared. After warming up, the printer
resumes printing the page that was affected by the
error.
Irregular Density
LED: On Line = off, Continue = off
Description: The print data sent to the printer requires too much
toner, CMYK density exceeds 280%, near the top
edge, which causes the printer to print making paper
jam around a paper source slot.
Remedy: Open the paper feed unit, clear the jam, and then
close the unit. Abandon the print job and turn the
printer off and back on.
Revision A
5-5