End Guide (Pl2.2.16), Sector Gear (Pl2.2.17) Removal - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2.5.3 END GUIDE (PL2.2.16), SECTOR GEAR (PL2.2.17) Removal

1. Take the UNIVERSAL TRAY out. (See Section 3.2.5.1.)
2. Move the END GUIDE to the right end. (= minimum paper size fits)
NOTE: After removing the FRONT GUIDE ASSEMBLY, hold the
BOTTOM PLATE ASSEMBLY down.
3. Remove 2 screws (black, tapped, 8mm) securing the FRONT
GUIDE ASSEMBLY and remove the FRONT GUIDE ASSEMBLY.
4. Push down the BOTTOM PLATE ASSEMBLY to lock it at the
bottom.
5. Turn the UNIVERSAL TRAY over and remove 5 screws (gold,
tapped, 8mm) securing the TRAY BOTTOM COVER. Then remove
the TRAY BOTTOM COVER.
6. Remove the SECTOR GEAR SPRING from the TRAY HOUSING
and SECTOR GEAR.
7. Release the joint for the hole in the SECTOR GEAR and the swivel
peg in the UNIVERSAL TRAY, and slide the SECTOR GEAR along
the groove to fit the round end of the groove to the peg in the END
GUIDE. Then remove the SECTOR GEAR.
(Continues to the next page.)
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-16.
END GUIDE (PL2.2.16), SECTOR GEAR (PL2.2.17) Removal (1)
Revision A
3-16