Epson ColorPage EPL-C8200 Service Manual page 275

EPSON ColorPage EPL-C8200
6. As the same manner, the parameter code is displayed in the
[Command] box. When you select a parameter code from the list, if
you double-click the command code and the command code does
not have a parameter code in the lower level, the [Error] window
appears.
7. Click the [Send] button to send the command.
NOTE:If you want to select another command without sending the
selected command, move the cursor into the parameter code
selection window. Click the right mouse button. The [Go
Back] button appears. Click the [Go Back] button to return to
the previous parameter code. Repeat this step until you find
the desired command.
8. If the selected command has its corresponding status, the status is
displayed in the [Status] box in HEX.
NOTE:When you want to go to either the ([Auto] or [Service]) menu,
first disconnect the connection (by clicking on the
[Disconnect] button), then go to another menu.
Chapter 4 Diagnostics
Inputting a Command Directly in the [Command] Box.
You can input a command into the [Command] box as follows:
1. Click the [Manual] tab. The Manual screen appears.
2. Establish the communication. (See Section 4.2.4.2 "Setting up the
communication".)
3. Enter a command code and parameter code in HEX in the
[Command] box. Enter a space as a delimiter within the code.
4. Click the [Send] button to send the command.
5. If the selected command has its corresponding status, the status is
displayed in the [Status] box in HEX.
NOTE: When you want to go to either the ([Auto] or [Service]) menu,
first disconnect the connection (by clicking the [Disconnect]
button), then go to another menu.
Revision A
4-11