Wiring Diagram - §7 - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200
A.3.3.7 Wiring Diagram - §7
Table A-28. Wiring Diagram - §7
Signal Name
AC N Neutral signal in the AC input from the power
supply (Heater power supply voltage).
AC L Line signal in the AC input from the power supply
(Heater power supply voltage).
TEMP. Signal that holds the Heat Roll surface
temperature. (Analog) (The temperature is
measured by the Thermistor in the Temperature
Sensor Assembly. The temperature is used to
determine the Fuser control temperature.)
FUSER EXIT PAPER SENSED Signal from the Fuser Exit Sensor to detect the
(L) 5VDC paper in the Fuser.
FUSER ASSEMBLY SENSED Signal to detect the Fuser Assembly connection.
(L) 5VDC
OIL ROLL SENSED (L) 5VDC Signal to detect the Oil Roll Assembly.
NEW OIL ROLL SENSED (L) Signal to detect New/Old of the Oil Roll Assembly.
5VDC
• When the power is turned on, a conductivity


Thermal Fuse fusion temperature: 141 C (+0 C/-6 C)


Thermostat contact opening temperature: 150 C 5.6 C


Heater rated power
- P/R Heater: 480 24W (50V)
- H/R Heater: 360 18W (50V)
Chapter A Appendix
Description
check is performed to detect New/Old of the Oil
Roll Assembly.
Revision A
A-45