Epson ColorPage EPL-C8200 Service Manual page 318

EPSON ColorPage EPL-C8200
(1) Commands
Table 4-62. Command List of the Parameter Control (1/2)
Command
Command
code (Hex)
LIFCNTSET # 80
LIFLIMSET # 81
LIFDEF # 82
TIMSET # 83
TIMDEF # 84
CTLSET # 85
CTLDEF # 86
STSSET # 87
LIFWNGSET # 88
LIFWNGDEF # 89
LIFCNTR D0
LIFLIMR D1
TIMSETR D2
TIMUNITR D3
Chapter 4 Diagnostics
Parameter
Description
code
1.LIFE, 2.V1,
3.V2, 4.V3, Writes data in the life counter.
5.V4
<Do not use this command
1.LIFE, 2.V1,
unless instructed!>
3.V2, 4.V3,
5.V4
Changes the life over value.
Changes the life over value to
1.LIFE
the default.
<Do not use this command
1.TIM, 2.V1,
unless instructed!>
3.V2, 4.V3
Changes the time out value.
Changes the time-out value to
1.TIM
the default.
1.CTL, 2.V1,
Changes the control value.
3.V2, 4.V3
Changes the control value to
1.CTL
the default.
1.STC, 2.V1, Writes data in the statistical
3.V2, 4.V3 counter.
1.LIFE, 2.V1, <Do not use this command
3.V2, 4.V3, unless instructed!> Changes
5.V4 the life warning value.
Changes the life warning
1.LIFE
value to the default.
1.LIFE Reads the life counter.
1.LIFE Reads the life over value
1.TIM Reads the time-out value.
1.TIM Reads the time-out unit.
Table 4-63. Command List of the Parameter Control (2/2)
Command Parameter
Command
code (Hex)
TIMMINR D4 1.TIM
TIMMAXR D5 1.TIM
CTLVALR D6 1.CTL
CTLSETR D7 1.CTL
CTLACCSR D8 1.CTL
CTLMINR D9 1.CTL
CTLMAXR DA 1.CTL
STCCNR DB 1.STC
LIFEDEFR DC 1.LIFE
TIMDEFR DD 1.TIM
CTLDEFR DE 1.CTL
LIFWNGR F0 1.LIFE
LIFWDEFR F1 1.LIFE
CRIDR F2 None
CRMDR F3 None
A command with "#" is a command without a responding status.
Note: The parameter codes V1 through V4 are in decimal. Enter a value from the
upper byte so that it can be read normally.
Revision A
Description
code
Reads the minimum time-out
value.
Reads the maximum time-out
value.
Reads the controlled value (that
changes).
Reads the control value.
Reads the privilege to access
the control value.
Reads the minimum control
value.
Reads the maximum control
value.
Reads the statistical counter.
Reads the default life-over
value.
Reads the default time-out
value.
Reads the default control value.
Reads the life warning value.
Reads the default life warning
value.
Reads the CRUM ID.
Reads the CRUM data.
4-54