Link Assembly Removal; Regi Roll Assembly Removal - Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer Service Manual

Disassembly andAssemMy
3.2.4 Paper Transportation Section Disassembly
This section describes how to disassemble the paper transportation section.

3.2.4.1 Link Assembly Removal

1. Remove thetopcover. (Refer toSection3.2.l.2.)
2. Remove theleftcover. (Refer to Section 3.2.l.3.)
3. Pull out the paper cassette about IOcrn (3.94 inches) towards the front.
4. Open the front cover unit.
6. Remove CBB screws @43 x 8) securing the link assembly, and remove it from the ROS unit
2
frame.
7. Remove the link assembly while opening the lrnkspring.
Figure 3-23. Removing the Link Assembly

3.2.4.2 REGI Roll Assembly Removal

Disconnect connectors P/J26and P/J28 from the REGI roll assembly.
2.
3. Remove 3 CBB screws (M3 x 8) securing the REGI roll assembly. (1 screw holds the green earth
wire.)
4. Remove the REGI roll assembly.
Figure 3-24. Removin the REGI Roll Assembly
3-16
Shatter Lever
Rev. A