Pre-Regi. Clutch Removal (Pl5.2.8) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.8.5 PRE-REGI. CLUTCH Removal (PL5.2.8)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
NOTE: In the following step, hold the REGI. CHUTE ASSEMBLY to
keep it closed while turning over the MAIN P/H ASSEMBLY.
4. Remove 2 screws (gold, tapped, 8mm) securing the PRE-REGI.
GEAR ASSEMBLY and remove it.
Figure 3-47. PRE-REGI. CLUTCH Removal (1/2)
5. Disconnect the connector (P/J95) for the PRE-REGI. CLUTCH from
the back of the MAIN P/H ASSEMBLY, and release the harness.
NOTE: In the following step, be careful not to drop gears as they will
be disengaged.
Chapter 3 Disassembly and Assembly/Adjustment
6. Remove 2 E-rings fixing the PRE-REGI. SUPPORT and remove the
PRE-REGI. SUPPORT toward the rear.
7. Among 2 PRE-REGI. GEAR 1, remove the outer one to the rear
from the stud.
8. Disconnect the connector (P/J95) for the PRE-REGI. CLUTCH
through the hole to the back of the MAIN P/H ASSEMBLY.
9. Remove the PRE-REGI. CLUTCH from the stud and remove the
PRE-REGI CLUTCH.
Figure 3-48. PRE-REGI. CLUTCH Removal (2/2)
n When installing the PRE-REGI. CLUTCH, make sure
the notch on the clutch is properly aligned with the pin
on the MSI FRAME ASSEMBLY.
n Route the harness carefully so it does not touch any
gear.
n If it is hard to connect the PRE-REGI CLUTCH
connector, release the harness from the clump, then
connect the connector.
Revision B
3-43