Waste Ink Pad Assembly Removal - Epson 440 Service Manual

3.2.4

Waste Ink Pad Assembly Removal

1. Removing the upper housing (Refer to section 3.2.1)
2. Removing the control panel assembly (Refer to section 3.2.3)
3. Remove 1 screw (No.4) at the right-hand side of the printer mechanism, that fixing "Waste Ink Pad
Assembly".
4. Remove "SPACER, TRAY" fixing "Waste Ink Pad Assembly" at the left-hand side of the printer
mechanism and remove "Waste Ink Pad Assembly" by pulling it downward.
When you replace "Waste Ink Pad Assembly" to new one, be sure to perform the ink counter reset
operation. (Refer to Chapter 1 / Section 1.4.2 for details)
When re-installing "Waste Ink Pad Assembly", be sure that "Stopper, Stacker" that attached to the exit
roller shaft is correctly pushed in to back of the projections of "Waste Ink Pad Assembly".
Rev. A
CAUTION
WORK POINT
Figure 3-6. Waste Ink Pad Assembly Removal
Chapter 3 Disassembly and Assembly
3-9