Supply; Replacing The Cable Restraint On A Three-Input 240-A Dc Power Supply (Optional) - Juniper T640 Quick Start Manual

Hide thumbs Also See for T640:

Table of Contents

Figure 11: Three-Input 240-A DC Power Supply in 2-INPUT Mode

Replacing the Cable Restraint on a Three-Input 240-A DC Power Supply (Optional)

Each three-input 240-A DC power supply is shipped with the standard cable restraint

shown in

Figure 12 on page

box.

If your DC power cables are too large or inflexible to fit into the standard cable restraint,

we recommend that you remove the standard cable restraint and install the optional

cable restraint (see

Figure 13 on page

To replace the cable restraint on a three-input 240-A DC power supply:

Removing the Standard Cable Restraint from a Three-Input 240-A DC Power

Supply on page 25

Installing the Optional Cable Restraint on a Three-Input 240-A DC Power

Supply on page 26

Removing the Standard Cable Restraint from a Three-Input 240-A DC Power Supply

The cable restraint is located on the right edge of the power supply faceplate. To remove

the standard cable restraint:

Loosen the captive screw on the standard cable restraint.

Remove the cable restraint from the power supply.

26. Two optional cable restraints are shipped in the accessory

26) on each three-input 240-A DC power supply.

Table of Contents