Configuring Dc Power On A T4000 (Three 80-A Cables On A Six-Input Dc Power Supply) - Juniper T4000 Hardware Manual

Configuring DC Power on a T4000 (Three 80-A Cables on a Six-Input DC Power Supply)

Copyright © 2018, Juniper Networks, Inc.
When you connect three 80-A DC power cables to six inputs using terminal jumpers to
each power supply, you must specify the input current in the software. In addition, you
must also indicate that six input feeds are used. If the number of physical input feeds
receiving power does not match the number of configured inputs, the router displays an
alarm message.
Configure the number of input feeds to indicate that six feeds are used to connect the
1.
three 80-A DC power cables by means of terminal jumpers.
[edit]
user@host# set chassis pem feeds 6
NOTE: The default number of input feeds is 6.
Configure the input current to indicate that 40-A is used to provide input current. Each
2.
80-A DC power cable connects to two inputs by means of a terminal jumper, with
each input receiving approximately 40 amps.
[edit]
user@host# set chassis pem input-current 40
NOTE: The default input current is 60-A.
(Optional) If the power has been underprovisioned for your configuration, some FPCs
3.
might not be brought online if the available power capacity is exceeded. When you
reboot the router, FPCs are brought online based on the default setting of the
fru-poweron-sequence
to change the default order in which FPCs are brought online when the router is
rebooted.
[edit]
user@host# set chassis fru-poweron-sequence fru-poweron-sequence
NOTE: The default is the numerical order of the FPC slots (0 through 7).
(Optional) Use the
4. show
correct.
[edit]
user@host# show
pem {
feeds 6;
input-current 40;
}
Chapter 24: Configuring the JUNOS Software
command. You can use the
statement to display the configuration to verify that it is
fru-poweron-sequence command
215