Supply; Setting The Input Mode Switch On A T1600 Three-Input 240-A Power Supply - Juniper T1600 Hardware Manual

Copyright © 2010, Juniper Networks, Inc.

Setting the Input Mode Switch on a T1600 Three-Input 240-A Power Supply

NOTE: Do not set the input mode switch if the power supply is installed in
the chassis. If the power supply is already installed, you must remove it before
setting the input mode switch.
NOTE: For the T1600 router, you must set the input-mode switch to
mode.
To set the input mode switch:
Using a screwdriver, loosen the captive screw holding the metal cover over the input
1.
mode switch (see Figure 149 on page 264).
Rotate the metal cover away from the input mode switch to expose the switch.
2.
Check the setting of the input mode switch. Use a flashlight, if necessary. In
3.
mode, the switch is located all the way to the left.
Use a sharp, nonconductive object to slide the switch all the way to the left to set the
4.
power supply to
3-INPUT
CAUTION: Do not use a pencil, because fragments can break off and cause
damage to the power supply.
Rotate the metal cover over the input mode switch, and use a screwdriver to tighten
5.
the captive screw.
Figure 149 on page 264 shows the input mode switch.
Chapter 17: Replacing T1600 Router Hardware Components
.
3-INPUT
3-INPUT
263