Vrrp Vrid Timer Advertise - 3Com S7906E Command Reference Manual

Description
Use the vrrp vrid priority command to configure the priority of the switch in the specified VRRP group.
Use the undo vrrp vrid priority command to restore the default.
By default, the priority of a switch in a VRRP group is 100.
Before executing the command, create a VRRP group on an interface and configure the virtual IP
address of the VRRP group.
In VRRP, the role that a switch plays in a VRRP group depends on its priority. A higher priority
means that the switch is more likely to become the master. Note that priority 0 is reserved for
special use and 255 for the IP address owner.
If the switch is the IP address owner, its priority is always 255. Therefore, it will be the master so
long as it is functioning normally.
Examples
# Set the priority of VRRP group 1 on interface VLAN-interface 2 to 150.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1
[Sysname-Vlan-interface2] vrrp vrid 1 priority 150

vrrp vrid timer advertise

Syntax
vrrp vrid virtual-router-id timer advertise adver-interval
undo vrrp vrid virtual-router-id timer advertise
View
Interface view
Default Level
2: System level
Parameters
virtual-router-id: VRRP group number, in the range 1 to 255.
adver-interval: Interval at which the master in the specified VRRP group sends VRRP advertisements. It
ranges from 1 to 255 seconds.
Description
Use the vrrp vrid timer advertise command to configure the Adver_Timer of the specified VRRP
group.
Use the undo vrrp vrid timer advertise command to restore the default.
By default the Adver_Timer is 1 second.
The Adver_Timer controls the interval at which the master sends VRRP packets.
Note that:
1-10