Bridge Multicast Address - Cisco SPS2024 Reference Manual

Address Table Commands

bridge multicast address

bridge multicast address
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Default Configuration
Filtering Multicast addresses is disabled. All Multicast addresses are flooded to all
ports.
Command Mode
Global Configuration mode
User Guidelines
If Multicast devices exist on the VLAN, do not change the unregistered Multicast
addresses state to drop on the switch ports.
If Multicast devices exist on the VLAN and IGMP-snooping is not enabled, the
bridge multicast forward-all command should be used to enable forwarding all
Multicast packets to the Multicast switches.
Example
In the following example, bridge Multicast filtering is enabled.
Console(config)# bridge multicast filtering
The bridge multicast address Interface Configuration (VLAN) mode command
registers a MAC-layer Multicast address in the bridge table and statically adds
ports to the group. To unregister the MAC address, use the no form of this
command.
Syntax
bridge multicast address {
bridge multicast address {
interface-list
remove] {ethernet
no bridge multicast address {
mac-multicast-address
mac-multicast-address
port-channel-number-list
| port-channel
mac-multicast-address
ip-multicast-address
|
| ip-multicast-address
ip-multicast-address
|
5
}
} [add |
}
}
77