Spanning-Tree Link-Type - Cisco SPS2024 Reference Manual

Spanning Tree Commands

spanning-tree link-type

spanning-tree link-type
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
User Guidelines
This feature should be used only with interfaces connected to end stations.
Otherwise, an accidental topology loop could cause a data packet loop and
disrupt device and network operations.
Example
The following example enables PortFast on Ethernet port e15.
Console(config)# interface ethernet e15
Console(config-if)# spanning-tree portfast
The spanning-tree link-type Interface Configuration mode command overrides the
default link-type setting determined by the duplex mode of the port and enables
Rapid Spanning Tree Protocol (RSTP) transitions to the forwarding state. Use the
no form of this command to restore the default configuration.
Syntax
spanning-tree link-type {point-to-point | shared}
no spanning-tree link-type
Parameters
•
point-to-point —Indicates that the port link type is point-to-point.
•
shared — Indicates that the port link type is shared.
Default Configuration
The device derives the port link type from the duplex mode. A full-duplex port is
considered a point-to-point link and a half-duplex port is considered a shared link.
28
375