Show Ip Source-Guard Inactive - Cisco SPS2024 Reference Manual

IP Source Guard Commands

show ip source-guard inactive

show ip source-guard inactive
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The show ip source-guard inactive Privileged EXEC mode command displays the
IP source guard inactive addresses.
Syntax
show ip source-guard inactive
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
Since the IP source guard uses the Ternary Content Addressable Memory (TCAM)
resources, there may be situations where IP source guard addresses are inactive
because of lack of TCAM resources.
By default, every minute the software conducts a search for available space in the
TCAM for the inactive IP source guard addresses.
The ip source-guard tcam retries-freq Global Configuration mode command
changes the frequency or disables automatic retries for TCAM space.
This command displays the inactive IP source guard addresses.
Example
The following example displays the IP source guard inactive addresses.
Console# show ip source-guard inactive
TCAM resources search frequency: 10 minutes
16
233