Snmp-Server Group - Cisco SPS2024 Reference Manual

SNMP Commands

snmp-server group

snmp-server group
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Command Mode
Global Configuration mode
User Guidelines
This command can be entered multiple times for the same view record.
The number of views is limited to 64.
No check is made to determine that a MIB node corresponds to the "starting
portion" of the OID until the first wildcard.
Example
The following example creates a view that includes all objects in the MIB-II system
group except for sysServices (System 7) and all objects for interface 1 in the MIB-
II interface group.
Console(config)# snmp-server view user-view system included
Console(config)# snmp-server view user-view system.7 excluded
Console(config)# snmp-server view user-view ifEntry.*.1 included
The snmp-server group Global Configuration mode command configures a new
Simple Management Protocol (SNMP) group or a table that maps SNMP users to
SNMP views. Use the no form of this command to remove a specified SNMP
group.
Syntax
groupname
snmp-server group
readview
[read ] [write
no snmp-server group
{v1 | 2 | v3 {noauth | auth | priv} [notify
writeview
]
groupname {v1 | v2 | v3 [noauth | auth | priv]}
26
notifyview
]}
337