Ip Arp Inspection Logging Interval - Cisco SPS2024 Reference Manual

ARP Inspection Commands

ip arp inspection logging interval

ip arp inspection logging interval
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example assigns static ARP binding lists to a VLAN.
Console(config)# ip arp inspection list assign
The ip arp inspection logging interval Global Configuration mode command
configures the minimal interval between successive ARP SYSLOG messages. To
return to the default configuration, use the no form of this command.
Syntax
ip arp inspection logging interval {
no ip arp inspection logging interval
Parameters
•
seconds — Specifies the minimal interval between successive ARP
SYSLOG messages. A 0 value means that a system message is
immediately generated. (Range: 0-86400)
•
infinite — Specifies SYSLOG messages are not generated.
Default Configuration
The default value is 5 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
seconds
| infinite}
4
71