Traffic-Shape - Cisco SPS2024 Reference Manual

QoS Commands

traffic-shape

traffic-shape
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The traffic-shape Interface Configuration (Ethernet, port-channel) mode command
configures the shaper of the egress port/queue. Use the no form of this command
to disable the shaper.
Syntax
committed-rate excess-burst
traffic-shape {
queue-id
no traffic-shape [
Parameters
•
committed-rate
(bps). (CIR range: 64–62500 Kbps,
CBS: 8192-16769020 bytes)
•
excess-burst
— Specifies the excess burst size (CBS) in bytes.
•
queue-id
— Specifies the queue number to which the shaper is assigned.
Default Configuration
No shape is defined.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command activates the shaper on a specified egress port or egress queue.
To activate the shaper on an egress port, enter the Interface Configuration mode
and specify the port number. Then run this command without the queue-id
parameter. The CIR and the CBS will be applied to the specified port.
To activate the shaper for specific queue, run this command with the queue-id
parameter.
]
— Specifies the average traffic rate (CIR) in bits per second
queue-id
} [ ]
23
289