QoS Commands
set
set
NOTE
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The set Policy-map Class Configuration mode command sets new values in the IP
packet.
Syntax
set {dscp
new-dscp
no set
Parameters
•
new-dscp
— Specifies a new DSCP value for the classified traffic. (Range:
0-63)
•
queue-id
— Specifies an explicit queue ID for setting the egress queue.
•
new-cos
— Specifies a new user priority for marking the packet. (Range: 0-
7)
NOTE: In SPS2xx 'set cos' command will not affect regular IP traffic, it will affect only
non IP traffic, unless the outgoing port is Gigabit port
Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
This command is mutually exclusive with the trust Policy-map Class Configuration
command within the same policy map.
| queue
queue-id
| cos
new-cos
}
23
279