Cisco SPS2024 Reference Manual page 289

QoS Commands
wrr-queue cos-map
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Default Configuration
CoS values are mapped to 8 queues as follows:
Cos0 is mapped to queue 3.
Cos1 is mapped to queue 1.
Cos2 is mapped to queue 2.
Cos3 is mapped to queue 4.
Cos4 is mapped to queue 5.
Cos5 is mapped to queue 6.
Cos6 is mapped to queue 7.
Cos7 is mapped to queue 8.
Command Mode
Global Configuration mode
User Guidelines
This command can be used to distribute traffic into different queues, where each
queue is configured with different Weighted Round Robin (WRR) and Weighted
Random Early Detection (WRED) parameters.
It is recommended to specifically map a single VPT to a queue, rather than
mapping multiple VPTs to a single queue. Use the priority-queue out Interface
Configuration (Ethernet, Port-channel) mode command to enable expedite queues.
Example
The following example maps CoS 7 to queue 2.
Console(config)# wrr-queue cos-map 2 7
23
287