Port Storm-Control Broadcast Enable - Cisco SPS2024 Reference Manual

Ethernet Configuration Commands

port storm-control broadcast enable

port storm-control broadcast enable
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration of jumbo frames on the device.
Console# show port jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset
The port storm-control broadcast enable Interface Configuration (Ethernet) mode
command enables Broadcast storm control. Use the no form of this command to
disable Broadcast storm control.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode
command, to set the maximum allowable Broadcast rate.
12
175