Bridge Multicast Forward-All - Cisco SPS2024 Reference Manual

Address Table Commands

bridge multicast forward-all

bridge multicast forward-all
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Default Configuration
No forbidden addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
Example
In this example, MAC address 0100.5e02.0203 is forbidden on port e9 within
VLAN 8.
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03
Console(config-if)# bridge multicast forbidden address
01:00:5e:02:02:03 add ethernet e9
The bridge multicast forward-all Interface Configuration (VLAN) mode command
enables forwarding all Multicast packets on a port. Use the no form of this
command to restore the default configuration.
Syntax
bridge multicast forward-all {add | remove} {ethernet
port-channel-number-list
no bridge multicast forward-all
}
interface-list
| port-channel
5
80