Snmp-Server Engineid Local - Cisco SPS2024 Reference Manual

SNMP Commands

snmp-server engineID local

snmp-server engineID local
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The snmp-server engineID local Global Configuration mode command specifies
the Simple Network Management Protocol (SNMP) engineID on the local device.
Use the no form of this command to remove the configured engine ID.
Syntax
snmp-server engineID local {
no snmp-server engineID local
Parameters
•
engineid-string —
(Range: 5-32 characters)
•
default — The engine ID is created automatically based on the device MAC
address.
Default Configuration
The engine ID is not configured.
If SNMPv3 is enabled using this command, and the default is specified, the default
engine ID is defined per standard as:
•
First 4 octets — first bit = 1, the rest is IANA Enterprise number = 674.
•
Fifth octet — set to 3 to indicate the MAC address that follows.
•
Last 6 octets — MAC address of the device.
Command Mode
Global Configuration mode
engineid-string
| default}
Specifies a character string that identifies the engine ID.
26
346