Mdix - Cisco SPS2024 Reference Manual

Ethernet Configuration Commands

mdix

mdix
NOTE
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
In the following example, flow control is enabled on port 1.
Console(config)# interface ethernet 1
Console(config-if)# flowcontrol on
The mdix Interface Configuration (Ethernet) mode command enables cable
crossover on a given interface. Use the no form of this command to disable cable
crossover.
(SPS224G4 combo ports) This command applies when the copper port is used.
The configuration does not apply when an SFP is plugged to the port.
Syntax
mdix {on | auto}
no mdix
Parameters
•
on — Manual mdix is enabled.
•
auto — Automatic mdi/mdix is enabled.
Default Configuration
The default setting is auto.
Command Mode
Interface Configuration (Ethernet) mode
12
160