Dot1X Single-Host-Violation - Cisco SPS2024 Reference Manual

802.1x Commands

dot1x single-host-violation

dot1x single-host-violation
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
User Guidelines
•
User-based VLAN assignment is supported only in 802. 1 x multiple
sessions.
•
The configuration of the parameter is allowed only when the port is Forced
Authorized or Forced Unauthorized.
The dot1x single-host-violation Interface Configuration (Ethernet) mode command
configures the action to be taken when a station whose MAC address is not the
supplicant MAC address attempts to access the interface. Use the no form of this
command to restore the default configuration.
Syntax
dot1x single-host-violation {forward | discard | discard-shutdown} [trap
o dot1x single-host-violation
Parameters
•
forward — Specifies that each station should be 802. 1 x authenticated. This
mode is also called 'multiple sessions'.
•
discard — Discards frames with source addresses that are not the
supplicant address.
•
discard-shutdown — Discards frames with source addresses that are not
the supplicant address. The port is also shut down.
•
seconds—
trap
amount of time in seconds between consecutive traps. (Range: 1- 1000000)
Default Configuration
Frames with source addresses that are not the supplicant address are discarded.
No Traps.
Indicates that SNMP traps are sent. Specifies the minimum
36
seconds
]
538