Qos Map Policed-Dscp - Cisco SPS2024 Reference Manual

QoS Commands

qos map policed-dscp

qos map policed-dscp
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The qos map policed-dscp Global Configuration mode command modifies the
policed-DSCP map for remarking purposes. Use the no form of this command to
restore the default map.
Syntax
qos map policed-dscp
no qos map policed-dscp
Parameters
•
dscp- list
— Specifies up to 8 DSCP values separated by a space. (Range:
0-63)
•
dscp-mark-down
Default Configuration
The default map is the Null map, which means that each incoming DSCP value is
mapped to the same DSCP value.
Command Mode
Global Configuration mode.
User Guidelines
DSCP values 3,11,19... cannot be remapped to other values.
Example
The following example marks down incoming DSCP value 3 as DSCP value 43 on
the policed-DSCP map.
Console(config)# qos map policed-dscp 3 to 43
Reserved DSCP. DSCP 3 was not configured.
dscp-list dscp-mark-down
to
— Specifies the DSCP value to mark down. (Range: 0-63)
23
295