VLAN Commands
switchport customer vlan
switchport customer vlan
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The switchport customer vlan Interface Configuration (Ethernet, port-channel)
mode command sets the port's VLAN when the interface is in customer mode. Use
the no form of this command to restore the default configuration.
Syntax
switchport customer vlan
no switchport customer vlan
Parameters
•
vlan-id —
VLAN ID of the customer.
Default Configuration
No VLAN is configured.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures Ethernet port 1 to discard untagged frames at
ingress.
Console(config)# interface ethernet 1
Console(config-if)# switchport customer vlan
vlan-id
34
497