Cisco SPS2024 Reference Manual page 52

ACL Commands
permit (ip)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
•
destination
— Specifies the destination IP address of the packet. Specify
any to indicate IP address 0.0.0.0 and mask 255.255.255.255.
•
destination-wildcard
IP address. Use 1s in bit positions to be ignored. Specify any to indicate IP
address 0.0.0.0 and mask 255.255.255.255.
•
protocol
— Specifies the abbreviated name or number of an IP protocol.
(Range: 0-255). The following table lists the protocols that can be specified:
IP Protocol
Internet Control Message Protocol
Internet Group Management Protocol
IP in IP (encapsulation) Protocol
Transmission Control Protocol
Exterior Gateway Protocol
Interior Gateway Protocol
User Datagram Protocol
Host Monitoring Protocol
Reliable Data Protocol
Inter-Domain Policy Routing Protocol
Ipv6 protocol
Routing Header for IPv6
Fragment Header for IPv6
Inter-Domain Routing Protocol
Reservation Protocol
General Routing Encapsulation
Encapsulating Security Payload (50)
Authentication Header
ICMP for IPv6
— Specifies wildcard to be applied to the destination
Abbreviated
Name
icmp
igmp
ip
tcp
egp
igp
udp
hmp
rdp
idpr
ipv6
ipv6-route
ipv6-frag
idrp
rsvp
gre
esp
ah
ipv6-icmp
3
Protocol
Number
1
2
4
6
8
9
17
20
27
35
41
43
44
45
46
47
50
51
58
50