Show Ports Storm-Control - Cisco SPS2024 Reference Manual

Ethernet Configuration Commands

show ports storm-control

show ports storm-control
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
Example
The following example configures the maximum rate of unknown unicast storm
control for FE ports to 10M.
console(config)# port storm-control unknown-unicast
fastethernet rate 3500
The show ports storm-control Privileged EXEC mode command displays the
storm control configuration.
Syntax
show ports storm-control [
Parameters
•
interface
— A valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
interface
]
12
180