Radius-Server Source-Ip - Cisco SPS2024 Reference Manual

RADIUS Commands

radius-server source-ip

radius-server source-ip
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The radius-server source-ip Global Configuration mode command specifies the
source IP address used for communication with RADIUS servers. Use the no form
of this command to restore the default configuration.
Syntax
radius-server source-ip
source
no radius-source-ip
Parameters
•
source
— Specifies a valid source IP address.
Default Configuration
The source IP address is the IP address of the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the source IP address used for communication
with all RADIUS servers to 10. 1 . 1 . 1 .
console(config)# radius-server source-ip 10.1.1.1
source
24
310