Switchport Protected-Port Fastethernet - Cisco SPS2024 Reference Manual

VLAN Commands

switchport protected-port fastethernet

NOTE
switchport protected-port fastethernet
NOTE
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Default Configuration
Unprotected
Command Mode
Interface configuration (Ethernet, port-channel)
User Guidelines
Use this command to isolate unicast, multicast, and broadcast traffic at Layer 2
from other protected ports on the same switch.
The packet is still subject to the FDB decision and to all filtering rules.
Use the switchport protected-port fastethernet global configuration command set
the FE ports as protected ports. Use the no form of this command to set the FE
ports as unprotected ports.
This command is supported in SPS2xx devices.
Syntax
switchport protected-port fastethernet
no switchport protected-port fastethernet
Parameters
This command has no arguments or keywords.
34
479